Stop the Constant Lamp Burn-outs on Your SIG Blomax Line
If you’re constantly swapping out lamps on your SIG Blomax line, you know how frustrating it is. One pops, the line stops, and suddenly you’re losing cycle time and dealing with preforms that aren’t heating evenly. It’s a headache. Usually, this happens because the tubes just can’t handle the stress of heating up and cooling down over and over again. That’s why we built our Sidel replacement lamps to be tougher.
Why these don’t just “pop”
Most quartz tubes give up the ghost at the pinch seal or where the electrode hits. It’s a weak point. We changed the way the lamp is built to handle those rapid temperature swings better. By tweaking the quartz wall thickness and getting the halogen fill just right, we’ve cut down those internal pressure spikes. Basically, we made them sturdy enough to take the hit.
No fancy install required
You don’t need to rewire your oven or mess around with the lamp holders. These are simple drop-in replacements. They fit the exact same footprint and electrical specs as the OEM units. You get the same wattage and voltage you’re used to, but with a reinforced internal structure. It’s the same power, just a lot less fragile. Plus, the heat distribution stays uniform, so your preforms come out exactly how they should.
A quick heads-up on maintenance
Now, these lamps are tough, but they aren’t magic. They put out intense short-wave IR energy. If your reflectors are pitted or your cooling fans are choked with dust, that heat has nowhere to go. It soaks back into the ends of the lamp, creates a hotspot, and can kill even a reinforced tube. Keep your reflectors clean. It’s a small bit of effort that makes these lamps last way longer.