SIDEL 2002406262 lamp

Sat, 06 Jun 2026 03:26:24 +0800

On the blow molding line, uneven preform heating doesn’t just throttle the machine—it generates scrap and turns every shift into a chase. When the heating tunnel starts drifting, you need a lamp that hits the OEM spec and gets the temperature profile back in line, fast. What matters technically The SIDEL 2002406262 lamp is a direct-fit infrared emitter for Sidel stretch blow molders. It runs on the standard line voltage in the machine’s heating section and delivers stable short-wave output for quick, repeatable preform heating. The quartz envelope is selected for high thermal shock resistance, and the R7s connector end-type matches the existing sockets, so you swap a lamp without modifying the holder or rewiring the heating bank. Why it works in production On the floor, it’s about uptime and repeatability. This lamp restores the original heating geometry, so the edge-to-center swings that cause thickness issues and blow-out rejects stop. With consistent infrared energy, the blow molder holds the set profile tighter, cycle after cycle, which supports higher line speeds without pushing the heating zone into overshoot. You also get predictable maintenance intervals, so you plan lamp changes instead of reacting to drift. Here are the practical details Installation is straightforward, but the heating bank needs to be clean and the reflectors in good shape—coating buildup changes the energy density on the preform. Confirm voltage and polarity before swapping, and match the lamp to the exact length and end-fit. Handle the quartz with gloves; even a small surface contaminant can create a hot spot and cut service life.

2002406262 on Quartz Heating Master Solutions

SIDEL 2002406262 lamp